Currently, we are interested in the following items:
We are also interested in other products on our PDF document attached.
ALUMINIUM WIRE SCRAPS
We only accept overhead electricity wires that DO NOT contain Si and Mg and consist of a minimum of 99.3% and over aluminium.
These wires contain steel parts called ‘Clemens’; these must be separated. Also, some of these electricity wires have steel wire in them to stop wire hanging low in time. This also must be separated.
Item Quality standard
Tablet - CLEAN ALUMINUM LITHOGRAPHIC SHEETS
To consist of alloys 1100 and/or 3003, to be free of paper, plastic, excessively inked sheets and any other contaminants. Minimum of three inches in any direction.
Taint/Tabor - CLEAN MIXED OLD ALLOY SHEET ALUMINIUM
Shall consist of clean old alloy aluminium sheet and sheet utensil a scrap of two or more alloys, free of 7000 alloy series, foil, Venetian blinds, castings, hair wire, screen wire, food or beverage containers, pie plates, hub caps, radiator shells, aeroplane sheet foil, oil cans, bottle caps, plastic, dirt, and other foreign substances. Oil and grease not to total more than 1%. Up to 10% painted sheet, siding, and awnings permitted.
Brushed Aluminum Sheet specification.
All need to be pressed and palletized.
a) 1000 Series: 1050, 1060, 1070, 1100, 1200
b) 5000 Series: 5005, 5754
c) 8000 Series: 8006, 8079
2) Thickness: 0.20mm - 320mm
3) Width: 8mm - 2400mm
4) Length: 1220 or per customer's request
5) Temper: all tempers, H1X, H2X, H3X, O, HXXX
6) Continuous casting and hot rolled both available
Our terms and conditions will be as below;
Initally, one 20 foot container for testing (it can consist of more than one type of products required), then we shall start increasing the size of the container and frequency of shipment.
CIF Yilport Gebze Turkey (Incoterms 2010) Or CIF Izmit Port Turkey (Incoterms 2010) preferred.
Customs clearance will be handled by us.
Bale dimensions should be 50 cm x 60 cm x 80 cm (height x width x length). All materials should be pressed / briquetted and palletized.
If materials have tiny pieces you can put them in big bags. Big bags should be max. 1-meter height and max. 80 cm in width.
All materials should be loaded in a way allowing unloading safety with forklifts. (you can see the details on the attached pdf.)
Weight of each sow should be approx. 700 kgs for secondary aluminium.
Weight of each pallet (ingot bundles or baled scraps) should be approx 1000 kgs.
All ingots&sows have to be dry. Any material affected by water, snow, moisture will be rejected or claimed.
You can check more details in the attached file.
If you can supply materials according to the PDF document attached above physical conditions and chemical compositions, please inform me of the scrap type, capacity and price.
Thanking you in advance.